Repair, Restoration, Resurfacing and Beautification Systems Over Existing Concrete and Other Surfaces
 

Privacy Policy

Warranty & Disclaimer

5 Step procedure for Ultra Surface® SPRAY-TEXTURE System

Step 1 - Surface Preparation
Step 2 - Crack Repair
Step 3 - Patching holes, spalls and low spots
Step 4 - Resurfacing and Texturing with Ultra Surface Polymer Concrete
Step 5 - Colorcoating and/or Sealing

Step 3: Patching Holes, Spalls, Low Spots and Deteriorated Areas

After the surface preparation and crack repairs are completed, the next step is to patch any holes, spalls, low spots and/or deteriorated areas with Ultra Surface Polymer Concrete Patching Mix before starting the resufacing and texturing process.

Fig. 1
Patch Holes with Ultra Surface Polymer Concrete Patching Mix.

Fig. 2
Patch Spalls with Ultra Surface Polymer Concrete Patching Mix.

Fig. 3
Patch low spots with Ultra Surface Polymer Concrete Patching Mix.

Fig. 4
Patch deteriorated areas with Ultra Surface Polymer Concrete Patching Mix.

Fig. 5
Ultra Surface Polymer Concrete Patching Mix can be used for applications between 1/16th of an inch up to 2 inches deep and feathered to zero.

For more information about Ultra Surface Polymer Concrete Patching Mix call us toll free at (800) 232-8311 or click here to contact us by email.
Go To Step 1 2 3 4 5




© 2004 Concrete Solutions Inc., 3904 Riley St. San Diego CA, 92110


Built/Hosted by ESP Design Studio Inc.
For a quick view of our systems go to concrete resurfacing
Visit our new Concrete Countertop web site concrete countertop