|
Step 4 - Resurfacing and Texturing with Ultra Surface Polymer Concrete
Once the surface preparation, crack repair and patching (if needed) is completed, the next step is to apply a Squeegee/Bond coat of Ultra Surface Polymer Concrete over the entire surface to provide a smoothing coat and to help hide the repairs. The Squeegee/Bond Coat is applied between zero and 1/16th of an inch thick using the Ultra Surface Metal Edge Squeegee and our Resurfacer Bag Mix. After the Squeegee Coat dries, a Trowel Knockdown Texture can be applied using Ultra Surface Polymer Concrete, a hopper gun sprayer, spiked shoes and a trowel.
|
|
|
|
Fig. 1
Lightly spray the surface with water, no puddles.
|
|
|
|
|
|
Fig. 2
Detail the sides and edges with a paint brush or putty knife.
|
|
|
|
|
|
|
Fig. 3
Apply a Squeegee/Bond Coat using theMetal Edge Squeegee.
|
|
|
|
|
Fig. 4
When the surface is dry enough to walk on, scrape material out of the joints before dry.
|
|
|
|
|
|
Fig. 5
Apply a Trowel Knockdown Texture Coat of Ultra Surface Polymer Concrete using a hopper gun sprayer.
|
|
|
|
|
Fig. 6
While wearing spiked shoes, trowel the spray texture flat to create the knockdown finish desired. Allow to dry and clean out all joints again using a trowel or stand up scraper.
|
|
